Skip to content
English
Contact us
  • There are no suggestions because the search field is empty.

Correcting the position of reagent pump beads (simple method)

Remember to remove reagents from the device and clean the pumps with RO water before performing these steps. 

1. First of all, you need to remove the reagent pump. Remove it gently so as not to damage the cables. 

2. Remove the pump gently so that it exudes and so that you have easy access to it. 

3. Holding the rubber beads and hoses with one hand, pull them in opposite directions so it is marked in the photo. 

4. After completing these steps, install the pump back in its place.